Getting my UDS delivered tomorrow, - pretty stoked at this point! My only issue is that the guy that designs them cuts a small access door in the bottom. I asked about this and he said it acts as the intake and has never had problems with it. I was wondering if sealing it off with some silicon or hi temp tape would improve heat/temp retention that the UDS is known for. Any thoughts?
It's been awhile since I last posted, or did anything low & slow, but I am here to announce my return to glory, as it were lol.
I have been off exploring the world of homebrew, and having that pretty much nailed down, I will be setting up some nice brew & que events at my humble abode in beautiful Rio Linda.
If no one shows up, more for me :)
Anyways, here's to Que, and good HomeBrew!
- B916
It's been awhile since I last posted, or did anything low & slow, but I am here to announce my return to glory, as it were lol.
I have been off exploring the world of homebrew, and having that pretty much nailed down, I will be setting up some nice brew & que events at my humble abode in beautiful Rio Linda.
If no one shows up, more for me :)
Anyways, here's to Que, and good HomeBrew!
- B916
Last edited: