Hey gang,
Ok so another dumb question by this newbie. After reading some good things on this forum about the above setup for monitoring temps, I ordered one from A-Maze-N Products.
I have the OKJ Horizontal offset smoker. In reading the manual for the ET732, it states not to have the probe wires in a pinching situation like having the cover closed over them.
So what do most folks do in this case? Drill holes in the smoker?
I am focusing on hopefully sealing up my new OKJ here in the next few days, using Permatex around the cooking barrel and firebox lids, and now I need to put new holes in? Easy to tell I am new, what to do about these wires never occurred to me until I read the manual.
Thanks for any feedback on what others do in this case.
Don
Ok so another dumb question by this newbie. After reading some good things on this forum about the above setup for monitoring temps, I ordered one from A-Maze-N Products.
I have the OKJ Horizontal offset smoker. In reading the manual for the ET732, it states not to have the probe wires in a pinching situation like having the cover closed over them.
So what do most folks do in this case? Drill holes in the smoker?
I am focusing on hopefully sealing up my new OKJ here in the next few days, using Permatex around the cooking barrel and firebox lids, and now I need to put new holes in? Easy to tell I am new, what to do about these wires never occurred to me until I read the manual.
Thanks for any feedback on what others do in this case.
Don