OK... So after attending the N. FL. Gathering and getting smacked upside the head with sausage making... I want to make a "Mini" version of the smokehouse that a few members helped build for Jerry ...
I'm thinking 3'(w)x2'(d)x3'(t)... the frame made with 2x2's and just skin the outside with 1/4' hardy board (cement board)... I want to keep it as light as possible so it's somewhat portable... that's why no cement board liner on the inside of the frame.... here in Fl. I don't have to worry about cold ambient temps so no need to insulate... gonna make the pipe burner with 1" pipe... cut slits with sawzall about 1.5" apart... thinking 10 cuts will be good.... I was thinking this for the regulator, If the hole is small enough (1/16th or so) at the end of the hose...
http://www.homedepot.com/p/t/203009...rizontal1-3-_-NA-_-203009031-_-N#.UWsY2rUsnIE
thinking about a 2"x4" intake vent below the door (w/damper) and a 4" exhaust vent out the top....
That's a couple of my thoughts so far... need some of y'all's thought's on my thinking....
I'm thinking 3'(w)x2'(d)x3'(t)... the frame made with 2x2's and just skin the outside with 1/4' hardy board (cement board)... I want to keep it as light as possible so it's somewhat portable... that's why no cement board liner on the inside of the frame.... here in Fl. I don't have to worry about cold ambient temps so no need to insulate... gonna make the pipe burner with 1" pipe... cut slits with sawzall about 1.5" apart... thinking 10 cuts will be good.... I was thinking this for the regulator, If the hole is small enough (1/16th or so) at the end of the hose...
http://www.homedepot.com/p/t/203009...rizontal1-3-_-NA-_-203009031-_-N#.UWsY2rUsnIE
thinking about a 2"x4" intake vent below the door (w/damper) and a 4" exhaust vent out the top....
That's a couple of my thoughts so far... need some of y'all's thought's on my thinking....
Last edited: