- Oct 21, 2022
- 11
- 3
So I have a 2nd MES 30 that I got and the control board was bad so I rewired it from research done here and am attempting to use an Inkbird 106VH with it.
For whatever reason, with multiple k-type sensors when I do a boil test it reads 200.4, yet my 3 probes hooked up to my monitor read between 210.5-211.5. However, when I have the sensor in the smoker, and the probe placed very close to it and set it to 225, my probe reads out at like 307 yet the sensor is near 225 (after I get this figured out I will be able to tune properly I hope).
Do I have something hooked up wrong? If it were a consistent range that it were off I could adjust it (say 10.5 degrees based on the boil test), but if I were to crank the smoker I’d still be at like 297 or so.
I’m just very confused on what I need to do here, any help would be greatly appreciated. I did try to search, I really hope I didn’t miss the answer.
For whatever reason, with multiple k-type sensors when I do a boil test it reads 200.4, yet my 3 probes hooked up to my monitor read between 210.5-211.5. However, when I have the sensor in the smoker, and the probe placed very close to it and set it to 225, my probe reads out at like 307 yet the sensor is near 225 (after I get this figured out I will be able to tune properly I hope).
Do I have something hooked up wrong? If it were a consistent range that it were off I could adjust it (say 10.5 degrees based on the boil test), but if I were to crank the smoker I’d still be at like 297 or so.
I’m just very confused on what I need to do here, any help would be greatly appreciated. I did try to search, I really hope I didn’t miss the answer.