I wanted to pass this on. I know I've seen a lot of posts on putting the MES on wheels so it is easier to move around. I just bought a new MES from Sams club and while I was there I noticed this cart. It was perfect for the MES not only to move it around but to get it off the ground so I can reach it better without having to bend down on my knees. The item number is 135623 and the link to the cart on the Sams site is
http://www.samsclub.com/shopping/navigate.do?dest=5&item_nbr=135623&landing=135623 The best things about the cart are that it is stainless steel, holds up to 500 pounds... and was only $59.00.
The cart comes with three shelves. After adjusting the MES where I wanted it, I had one shelf left over. I took this shelf and cut it in two. I made one side a little bigger than the other.
After grinding the sharp spots down, I took a piece of 2 X 4 and cut it to fit on the ends. I rounded off the corners and put a coat of stain on them. I attached them to the ends using some mirror holders I had that were made for 1/8th inch mirror. It fit the wire rack perfectly.
So for about 65 bucks including tax, I've got a great cart to haul the MES around on. Just thought I'd share this. I know there are a lot of you out there looking for something to set your MES on.
Keep it Shhhhhhhhhhmokin!
http://www.samsclub.com/shopping/navigate.do?dest=5&item_nbr=135623&landing=135623 The best things about the cart are that it is stainless steel, holds up to 500 pounds... and was only $59.00.
The cart comes with three shelves. After adjusting the MES where I wanted it, I had one shelf left over. I took this shelf and cut it in two. I made one side a little bigger than the other.
After grinding the sharp spots down, I took a piece of 2 X 4 and cut it to fit on the ends. I rounded off the corners and put a coat of stain on them. I attached them to the ends using some mirror holders I had that were made for 1/8th inch mirror. It fit the wire rack perfectly.
So for about 65 bucks including tax, I've got a great cart to haul the MES around on. Just thought I'd share this. I know there are a lot of you out there looking for something to set your MES on.
Keep it Shhhhhhhhhhmokin!