MES 40" -how much assembly?

Discussion in 'Electric Smokers' started by annaceil, Oct 7, 2015.

  1. Just received my smoker-not out of box yet.  Began to think about assembly-how much assembly is there on this Masterbuilt Electric smoker?  Looks like a lot from the online manual!
     
  2. rabbithutch

    rabbithutch Master of the Pit OTBS Member SMF Premier Member

    Howdy, Anna! Welcome to the Smoking Meats Forums from Texas!

    I've had my MES long enough that I don't remember how much is required to get it ready for use, but it was not bad.

    Of course, I've reached the age where I can hide my own Easter Eggs, too!

    :yahoo:
     
  3. bearcarver

    bearcarver Smoking Guru OTBS Member

    It's not bad, Anna----Good directions & only need one tool---Phillips Screw Driver. (Plus a scissors or knife to cut ties & open things).

    Be careful---I could see it falling on it's face if you aren't careful opening the door before you put the bottom parts on.

    Bear
     

Share This Page