jweller
Fire Starter
If I understand correctly, it should be the same size as the FF->CC opening.Still need to figure out what distance I need to leave at the end of my rf plate for proper smoke flow. Any ideas??
If I understand correctly, it should be the same size as the FF->CC opening.Still need to figure out what distance I need to leave at the end of my rf plate for proper smoke flow. Any ideas??
Hey Dave. Will I need a air inlet in the upper portion of my firebox door or do I need to give her a test run to determine that? If I do need one, any idea on size? My firebox is approx. 25.5 X 23.75 X 22
Is there a rule of thumb for how much air in relation to the lower vent. 50% as large? Obviously with a slider, I can choke it down if need be, but I'd like to get it close to correct.Nick, morning.... It would be a good idea... The upper air inlets seem to make several improvements in SFB smokers... As far as size goes, I'd put 3 holes, similar to the lower air intakes and some sort of slide damper, or tilt damper.... may as well make it look like you wanted it there.. and planned for it......
Dave
Nick, morning.... It would be a good idea... The upper air inlets seem to make several improvements in SFB smokers... As far as size goes, I'd put 3 holes, similar to the lower air intakes and some sort of slide damper, or tilt damper.... may as well make it look like you wanted it there.. and planned for it......
Dave
Is there a rule of thumb for how much air in relation to the lower vent. 50% as large? Obviously with a slider, I can choke it down if need be, but I'd like to get it close to correct.