UDS Progress ( Temp Probe Set-Up )

Discussion in 'UDS Builds' started by osu redneck, Apr 20, 2010.

  1. osu redneck

    osu redneck Newbie

    Should be ready for some Q this weekend. [​IMG]

    Here is my temp probe set-up so that I can use a 12 inch probe or swap out for a digital 2 probe Maverick down the road.



    My basket
     
  2. coffee_junkie

    coffee_junkie Master of the Pit OTBS Member

    Looks good, I have the same sort of setup, you will notice that the temps where the thermo is located can be 10-20* different than at grate level, also the temps at the outside of the barrel will vary also. Test with a digital also so you know how the drum really runs.
     
  3. rbranstner

    rbranstner Smoking Guru OTBS Member

    Looks good that should work. You are going to love smoking on that baby!
     
  4. osu redneck

    osu redneck Newbie

    Hmmm, I didn't know that they could vary that much over an inch. Good to know! I know each drum is different but on yours are you seeing higher or lower temps at grate level compared to where my probe is?
     
  5. ddave

    ddave Master of the Pit OTBS Member SMF Premier Member

    I think it varies as the fire works its way around the charcoal basket.

    Don't try to measure it in too many places at the same time or worry too much about the variation. You'll just get frustrated. [​IMG] Pick a spot to measure, call it the control point and smoke on. [​IMG]

    Dave
     
  6. pandemonium

    pandemonium Master of the Pit

    Nice, the way you did the nipples for the probes. ohh god i just said nipples and probes in the same sentence nuk nuk nuk!! No but really tjhats a nice looking UDS and Your gonna love using it!!!
     
  7. meateater

    meateater Smoking Guru SMF Premier Member

    Everything looks good so far, I see that your drum is still raw. Make sure you burn it in well before a great smoke job. [​IMG]
     

Share This Page