Mounting fire box

Discussion in 'Reverse Flow' started by tgrimmett, Jun 15, 2014.

  1. tgrimmett

    tgrimmett Fire Starter

    I'm building a rf offsett, my fb is 20x24 it calls for a fb to cc opening of 8 inches , I have a piece of 8 inch pipe . If I mounted it cross ways under the bottom were the rf plate starts would it work good if I put the pipe between the fb an cc to connect them that way?
     
  2. tgrimmett

    tgrimmett Fire Starter

    Somethin like this
     
  3. What is you cook chamber size? What is the FB to CC opening (square inches) suggested by the pit calculator? Without looking at the exact numbers, an 8" pipe doesnt seem large enough to get the required FB/CC opening size for good airflow.

    More details and your calculations would help.
     
  4. tgrimmett

    tgrimmett Fire Starter

    Cooking chamber is 20x60,fb is 20x24
     
  5. So you cook chamber is a cylinder 20" diameter by 60" long? Fire box is also a cylinder at 20" diameter by 24" long? Your sketch above suggests a square fire box but you didnt provide a 3rd dimension if that is the case......

    Have you done the calculations on the BBQ calculator?
     
  6. daveomak

    daveomak Smoking Guru OTBS Member SMF Premier Member

    My calculator puts the FB/CC opening about 75 sq. in...... FWIW....

    20 x 20 x .7854 x 60 x .004 = 75 ish for a reverse flow
     
    Last edited: Jun 16, 2014
  7. tgrimmett

    tgrimmett Fire Starter

    Thanks for the advice , the square in the drawing is a round pipe I was Turing crosss ways , but I decided to mount end to end like the picture Dave posted , I got it mounted man it was tought it's 3/8 inch pipe with the end caps being 1/2 in plate that sucker is heavy , I'm hoping to mount it to the trailer tmorrow
     

Share This Page