Guys I am wiring up my PID, SSR and a plug in outlet into a hobby box, but am stuck trying to decipher these chinese instructions.
The SSR I have is a 40 amp/250v
it has 4 set screws..two on top and two on the bottom the bottom two have a line that says "INPUT" and under that it says 3-32vdc. Screw 4 has a "-" symbol and screw 3 has a "+" symbol
Now on the top..it doesn't say INPUT, it just says 24-380VAC and screw 1 and 2 both have a little ~ by them.
what hooks up to where on this?
2. on the PID, I have a thermocouple with 3 wires..a red or positive and a black with a yellow crimp on it..and then a blue wire...I assume the thermocouple connects nevative to screw 6, positive to screw 7..but what does the blue connector on the TC connect to on the PID? And lastly how do I connect power up to this unit, and what does my plug in that will control the blower motor connect to?
Sorry, I have so many questions..but these directions that came with the PID, TC and SSR are useless.
THanks for any help
Dan
The SSR I have is a 40 amp/250v
it has 4 set screws..two on top and two on the bottom the bottom two have a line that says "INPUT" and under that it says 3-32vdc. Screw 4 has a "-" symbol and screw 3 has a "+" symbol
Now on the top..it doesn't say INPUT, it just says 24-380VAC and screw 1 and 2 both have a little ~ by them.
what hooks up to where on this?
2. on the PID, I have a thermocouple with 3 wires..a red or positive and a black with a yellow crimp on it..and then a blue wire...I assume the thermocouple connects nevative to screw 6, positive to screw 7..but what does the blue connector on the TC connect to on the PID? And lastly how do I connect power up to this unit, and what does my plug in that will control the blower motor connect to?
Sorry, I have so many questions..but these directions that came with the PID, TC and SSR are useless.
THanks for any help
Dan