- Jan 27, 2016
- 3
- 10
Building a simple controller for a 5Gal 120V 1550W BIAB kettle. My temp controller is setup for testing with a SSR controlling a lamp. The temp probe works fine, so wiring seems OK. I may have messed up some settings trying to change from C-F.
Question is, if I wanted to maintain a temp. of 156F mash, and never allow more than 3F above or below that, what would the settings be for alm1 and alm2? Alm 2 light is perm on, with test temp set at 60F and lamp switches on and off when it should. Had a question about the lamp cycling on and off, but that seems to be when its just trying to hold temp at 60 exactly.
The Chinese/English instructions read like "super monkey death car"
Question is, if I wanted to maintain a temp. of 156F mash, and never allow more than 3F above or below that, what would the settings be for alm1 and alm2? Alm 2 light is perm on, with test temp set at 60F and lamp switches on and off when it should. Had a question about the lamp cycling on and off, but that seems to be when its just trying to hold temp at 60 exactly.
The Chinese/English instructions read like "super monkey death car"