Electric Smoker Build Help/Ideas needed

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

fishwrestler

Smoking Fanatic
Original poster
OTBS Member
Apr 4, 2010
646
34
Loomis,CA
Good Morning,

Thanks to help from the forum I believe I have all the parts to build my electric smoker using a PID and 220V to wire up a 3400-watt oven element.
I have a couple of questions,
I want to use a metal 2 gang electrical box to mount the heating element in. Do these oven elements create heat around the electrical connections?
Should I use high temp wire in flex conduit to run power down to the element
would you hard-wire the element into the pid or use a plugged connection/

ANY PICTURES OF THE FOLLOWING WOULD BE APPRECIATED
1. Element connection to your wire and to the smoker
2. How you ran the wire from the PID to the element
3. If you mounted the PID to the smoker how and where did you mount it \

Thank you
 
  • Like
Reactions: JLeonard
What smoker/model are you using? I connected a power cord directly to the smoker's heating element. I then plugged the other end of the power cord into the PID. Way too simple.
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Hot Threads

Clicky