Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
Search results
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
I wanted to use RTD probes over K-type thermocouples. Auber mostly just has RTD probes for brewing/liquid. Anyone know of a good source for RTD probes for a smoker? Some can be really prices, and I've see some OLD (dead) links on other forums,etc referenceing some probes that were supposedly...
Where should a thermal switch to protect for an over heat be placed? (PID controlled smoker)
I see that MES smokers have them on the back wall about half way up or better.
Most ovens/ranges have them on the inner ceiling/top; however, ovens don't have an exhaust out/near the top either like a...
Wanted to ask for advice before I drill out a 3 inch hole so my MB mod. What distance between the 2600watt burner and the bottom of the hole, or should it be in reference to a heat deflector rack, etc?
My fridge build went on hold the last couple years. But its going to get finished before Spring. I have a couple of the Brinkmann 1500 elements from my other smokers I was going to use one of them with a
Auber Multi Purpose controller...
I have seen that the McMaster Carr high temp silicone gasket have been used with adherence using permatex red high heat RTV silicone gasket maker. But they are only rated for 350 degrees and I was looking for a bolt on solution.
The mcmaster Carr 12335A61 looks like it would fit just lIke the...
I'm trying to figure out the correct size for intake and exhaust sizes for a 17x21x38" smoker. There will be a box under the unit for a AMNPS (mailbox size or smaller) I was planning on using 3 separate 3/4 holes on that on its front side near the bottom. Then using a 2" pipe about 4inches long...
Problem #1 SOLVED (see post 6)
I was unable to get ALL of the miserable BLACK SEALANT TAR &$^%#$%^ out:
-I used a putty knife
-I used acetone
-I used Lacquer Thinner
... I re-read forum post's... and found something I missed a: HEAT GUN.... Used that.. worked way better
-I then Pressure...