Tube smoker lighting process?

Discussion in 'General Discussion' started by weldin smoker, Dec 4, 2015.

  1. Hey all,

    New on here. Have a square tube smoker 16 inches long, with a 2 3/8 inside dimension I made quite a few years ago from some heavy perforated sheet. Only tried using it a couple times. Just wondering what process you use to light your tube smokers. I have both pellets and chips. What's everybody else using? Thanks for any advice. Going to try to do a 12lb turkey and 2 tri tips tomorrow in an old cabinet unit I got going yesterday.
     
  2. driedstick

    driedstick Smoking Guru OTBS Member SMF Premier Member

    Can we get a pic ,,,, I use a small propane torch and I only do pellets in my ampts 

    A full smoker is a happy smoker 

    DS
     
     
  3. crankybuzzard

    crankybuzzard Smoking Guru Staff Member Moderator OTBS Member SMF Premier Member

    [VIDEO][/VIDEO]
     
  4. I'll get a pic in the morning. I light it with a propane torch as well for 30 seconds to a minute. This time I let it burn a little longer than usual, about 12 min. Seemed to work pretty well. That was at 5:00 pm, still a nice stream of light smoke. Tube was only about 1/4 full of hickory pellets.
     
  5. My ugly old cabinet. Had it for 9 years, first time using it
     

Share This Page