Starting my 1st UDS build!

Discussion in 'UDS Builds' started by tlcpokertables, Aug 28, 2013.

  1. Hi everyone,

    After a bit of research, I've decided to build my 1st UDS. I have the drum and bought most of the hardware for it. I'm about ready to burn the inside of the drum to get it any / all stuff out of it.  The drum itself appears to be in good condition.  However the entire inside has a rusted powder all it. I'm hoping the fire will take tare of this.  Either way, I know I have to put some elbow grease into sanding the inside and outside down to the bare metal. long do I burn the drum for?....and does the flames really need to go above the rim? (Backyard is a bit tight, and I have concerns about things around it).

    Any input would be great!

  2. wudy

    wudy Fire Starter

    I started one this week and hope to use it this weekend. I burnt two pallets in mine and payed it on the side to burn the sides and bottom . Took about an hour or so. Good luck.
  3. Sounds good! Good luck with yours too! Thanks for the reply!

Share This Page