rf plate

Discussion in 'Reverse Flow' started by odiefranklin, Sep 16, 2015.

  1. odiefranklin

    odiefranklin Newbie

    okay next question on planning out my smoker build- I'm thinking about just using two halves on my plate, sloping from right to left for my drain. 1/4", butt welded, so the two pieces will be wider on the left end (but drain toward the middle) than the right end, so when in place create a gradual slope inward and toward the left.

    I may not be explaining it good enough- I'm no engineer for sure, but I know I've seen a picture on here somewhere that someone has done this, and maybe could post it again or link me to it?

    I didn't want to do the angle iron the middle, maybe someone could tell be why the angle iron is a better idea I may change my mind.

    The plate overall will be approximately 46" wide by 23"

    Thanks! 
     
  2. daveomak

    daveomak Smoking Guru OTBS Member SMF Premier Member

  3. is2326

    is2326 Fire Starter

    My plates are equal size with the angle iron in the middle. They

    slopes 1/4 - 3/8 but I can level it out very easy with my trailer wheel.
     

Share This Page