Search results

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
  1. brianlhobbs

    Adding Door Latch(s) to MES

    I have seen mention of adding additional door latches to the MES. However, I can not find anything about where to obtain these latches. Should I just call Masterbuilt and order from them? Or is there a better source? Thanks, Brian
  2. brianlhobbs

    MES Temp Control Problem?

    I have been checking the temp control of my new 40" MES that I purchased from Sams. It looks like the unit's controller is about 20 deg off. I have used both a Taylor wired probe and a wireless probe and they both match the reading that the MES is running 20 Degrees too hot. So if I set the...
  3. brianlhobbs

    EZ Way To Stuff Fattie

    Last weekend I made a couple fatties in my KC Smoker. I used a 1 lb roll of Mild Tennessee Pride breakfast sausage to begin with. Since I did not want to try and mess around with a rolling pen, I tried the following method to stuff the fatties. It worked very well. I took pictures of the...
  4. brianlhobbs

    MES Newbie Questions

    I am an MES Newbie, just got my “Sams Club†MES last night and am going to try and season it and take on it itâ€8482s “maiden voyage†this weekend. So, in looking over past posts concerning the MES, I have a few questions that I have not seen discussed before. 1) Is the top mounted...
  5. brianlhobbs

    Hi From Indianapolis

    Hi all, Brian here, located in Indianapolis. I have been a lurker of this site for the past month, ever since I bought my “clearance priced†Rival K.C. Smoker from Wal-Mart. Following my purchase of this bargain priced smoker, I also purchased Jeffâ€8482s Rub and Sauce recipe. All I can say...
Top Bottom
Back
Clicky