Search results

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
  1. bower4311

    First Party Smoke Need Timing Advice

    I'm smoking/cooking pork shoulder for my twin daughters' birthday party. Planning on eating at noon on Saturday. I probably have 50+ pork shoulders under my belt. I used to smoke a lot of them when I was in college and had a ton of free time (cheap meat as well). We always had pulled pork in the...
  2. bower4311

    Building a Smoker

    I decided to build a smoker. I have a Smoke Hollow propane smoker currently. I'm going to use the element form there, may as well. A wind storm made the cheap thin smoker not good enough right now. I may use the same door, I may make the smoker bigger. Here is what I'm thinking. I enjoy the...
  3. bower4311

    Anyone Sell Wood?

    Hey, I do some smoking here and there, but I also sell firewood on the side. Would there be any market for wood cookies? Say, hickory and cherry. Flat rate USPS boxes aren't too expensive. Is there a price point? I wouldn't mind selling some wood. I cut all kinds of cherry, usually run into...
  4. bower4311

    Insulation and Coating Question

    I have a couple questions here. Has anyone used some sort of a board insulation that is in some way glued or attached to the walls on a vertical smoker? I tried the hot water heater insulation but it's just too messy. I figure there is someone out there that has tried board insulation. Any...
  5. bower4311

    Taylor 1470 Fix

    So I have one of these digitals. It's only lasted a few months now. Where the wire connects to the probe it has frayed. There are two wires I can see. One that is broke, one that is connected. If I cut the probe, then re-strip the wire and re-crimp, should I be fine? Anyone ever had to fix one...
  6. bower4311

    Taylor 1470 Fix

    So I have one of these digitals. It's only lasted a few months now. Where the wire connects to the probe it has frayed. There are two wires I can see. One that is broke, one that is connected. If I cut the probe, then re-strip the wire and re-crimp, should I be fine? Anyone ever had to fix one...
Top Bottom
Back
Clicky