Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
Recent content by silverado2100
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
Sorry I haven't been online in years, but I'll try and answer some questions. Its still up and running fine.
1.) It has been converted over to pid control with dual ssr's about three years ago.
2.) No problems with the factory insulation. The highest weve had it was 225 finishing some turkeys...
I'LL have to figure out the dimensions sometime, the smoke canister works good and puts out a ton of smoke but the aquarium pumps dont last very long so we run a line from the air compressor now to feed it air. I have a pid controller now that i just need to wire up, it will store 8 recipes and ramp
There are some people that totaly remove all the insulation and replace it,
we just took the section that we cut out for the burner and through it on the grill and cranked it up and checked it at every 100° to see for fumes/expansion it was fine al the way up to about 350 after that it started...
Dad pulled the it out of the garbage and added screws to hold the dowels in place. It has casters and is easy to wheel from the stuffing table to the smoker and then after done smoking it makes it easy to wheel outside for the spray/cool down of the sausage.
I belive the frame was from some...
we took the plastic trim off and replaced with aluminum trim, we took some foam from the smoker and put it on our gas grill and cranked all the burners and got up to 500 and it started to expand but there werent any noticable fumes, it should be fine for us cuz we never go over 200
electric all the way. with a 5,000 watt burner we dont worry about recovery, dont have to worry about changeing tanks/ running out easier to mantain, and you dont have to worry about fumes
sorry about your luck, there customer service was very good to us when we called about a dent in our grinder, we worked out a deal to get another $50 off.
if you need to you could prolly get your credit card company involved but thats a last resort