Recent content by remmy700p

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
  1. remmy700p

    Brinkmann Trailmaster Limited Edition

    Here you go...
  2. remmy700p

    Need advice

    Note: Leave the exhaust stack vent ALL THE WAY OPEN. Always. Control combustion using the intake vent. A closed exhaust vent can facilitate creosote buildup and nasty-tasting BBQ.
  3. remmy700p

    Brinkman Trailmaster - Lava Rocks vs Tuning Plates

    Don't put lava rock -- or anything else -- on the bottom of the smoker. You'll just mess up draft/flow. Check out my gallery of pics. I made a deflector from a cookie baking tray I got from Target for $12. Works great. I've written about it several places here.
  4. remmy700p

    Brinkmann Trailmaster Limited Edition

    The TMLE really wants to be a stick-burner, but don't change up your mix yet; just up the fuel volume first and see what happens.
  5. remmy700p

    Brinkmann Trailmaster Limited Edition

    Use more fuel. I'd recommend mesquite wood chunk about the size of baseballs/softballs. That'll get you the therms you need and the great smoke flavor. Here's the size I get (compared to a Kingsford briquet).
  6. remmy700p

    Weber Kettle upgrade?

    It's essentially more of a fuel mass problem than a heat retention problem. On cold days, get rid of that little smokenator setup and just bank your coals behind a couple firebricks laid slightly overlapped and then wrapped in aluminum foil and used as a barrier. Works great. Here's what I'm...
  7. remmy700p

    Smoker firebox rust inside and out

    I strongly suggest leaving the paint out of it. After a smoke, just get all the ash out (I use a cheapo 3" paintbrush from Harbor Freight to help with this), then you can spray/wipe with some Simple Green. Let dry, then spray a coat of non-stick cooking spray on the inside and wipe it into the...
  8. remmy700p

    Firebox Issue

    For those folks that use the firebox's existing lower grate to set your charcoal box on, I recommend using bolts to lift the grate up some off the bottom. I gives much better air flow and a lot more room for ash accumulation.
  9. remmy700p

    Flavor wood placement

    You don't want the wood to smoulder.... you want it to burn. Put it right on your hot coal bed. It's the gases from combustion that contributes to the "smoky" flavor we're looking for, not the billowing white smoke that arises from inefficient combustion.
  10. remmy700p

    Firebox Issue

    The flaking is a result of a poorly applied and cured --  or improper -- paint coating, not excess heat. The side firebox on an offset smoker needs to be able to get HOT, like 700F hot. Steel thickness has a lot to do with it, but you can't change that. Just scrub off the flaking stuff and...
  11. IMG_20150717_122141.jpg

    IMG_20150717_122141.jpg

    • remmy700p
    • Media item
    • Comments: 0
    • Album: Weber kettle help
  12. IMG_20150519_174544230.jpg

    IMG_20150519_174544230.jpg

    • remmy700p
    • Media item
    • Comments: 0
    • Album: Weber kettle help
  13. remmy700p

    Weber kettle help

    Here's my 18.5" Weber One-Touch Silver. Got it on sale at my local Target for US$52. I use it 3-4 times a month and only do indirect smokes on it. I bank my coals (via the minion method) and wood chunk behind two (slightly overlapped) firebricks wrapped in aluminum foil so they stay together...
  14. Weber kettle help

    Weber kettle help

  15. remmy700p

    Brinkmann Trailmaster Limited Edition

    The temp drops precipitously as you move the thermo reading down the sides of the FB. By the midpoint (where the two halves join), it's probably closer to the low 600F range.
See more
Top Bottom
Back
Clicky