Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
Recent content by flgolfer29
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
I recently purchased the same smoker, and I'll share what limited knowledge I can.
As far as the smoke amount, the chip tray almost maxed out with a combo of chips & chunks smoked very good for me between 200-250 degrees, longer than the recommended 1 cup full. Others have modified their wood...
Only in my limited testing the original set-up was better. When I tested the cake pan, it was sitting nearly on top of the ^ shaped fire shield. Others have removed the shield, this may work better. However, the most recent test i was getting acceptable smoke.
Overall, I'm very pleased with...
Update: I purchased a direct connect hose to tie-in with a gas stub-out from our home. This enabled me to get temps up to 320 degrees. Not as hot as I'd like to achieve, but hot enough for most of the cooking I will do.
The cake pan mod described in original post, didn't work to good for me...
I'm not sure about the cooler method half-way through the smoke. But, I would just begin my cook 4 hours before the guests arrive, you still have one hour of smoke after guests arrive.
Recently I purchased a 44in Masterbuilt smoker from Sam's Club, model #20051214, and early indications things were looking great. A door seal kit was added prior to the burn-in.
The initial burn-in the smoker performed very well, and the first cook, ribs with all the fixings turned out great. ...
I recently purchased the Masterbuilt 44" propane cooker. Can anyone share where to buy additional 44" cooking racks? I've Google searched but can't locate them.
Thanks in advance ! !
joe
I put the smoker together last night and haven't fired it up yet. Based on recommendations here, I ordered a gasket kit and probably won't season the smoker until it has been added. The consensus is the wood chip/chunk set-up from the factory is unsatisfactory, but I will give it a test just...
I realize this is an old thread, however, I wanted to share my opinion of the cover. Like tpalshadow mentioned, the cover I purchased would not fit either. I was able to get the cover about 2/3 of the way on but no further, it began to tear on one of the corners of the smoker. It may have fit...
I went to Sam's in Panama City last Saturday for a 40" MES. They only had the display remaining (they wouldn't sell), I called a couple days later and they had three. I bought one Wednesday.
joe