Toggle sidebar

Recent content by beerdrinker

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
  1. beerdrinker

    New Dyna-Glo vertical offset smoker

    I used the nomex between the firebox and cooking chamber and also had to add bolts to close the gap that opens up when it gets hot.
  2. beerdrinker

    New Dyna-Glo vertical offset smoker

    It is a baking pan that I cut to fit. It will sit on the bolts I added to secure the firebox better. I am thinking about putting holes in it to allow even heat displacement. I also added a screen between the chambers because when I was adding fuel to the firebox I was getting a coating of ash in...
  3. beerdrinker

    New Dyna-Glo vertical offset smoker

    I bought this smoker off Amazon for $160. I sprayed it with high heat paint before assembly to cover any scratches and to hold off any rust. I used the nomex gaskets around the doors, between the firebox and cooking chamber and behind the thermometer. I drilled 2 holes in the side and put...
  4. New Dyna-Glo vertical offset smoker

    New Dyna-Glo vertical offset smoker

  5. IMG_5455.JPG

    IMG_5455.JPG

    • beerdrinker
    • Media item
    • Comments: 0
    • Album: New Dyna-Glo vertical offset smoker
  6. IMG_5446.JPG

    IMG_5446.JPG

    • beerdrinker
    • Media item
    • Comments: 0
    • Album: New Dyna-Glo vertical offset smoker
  7. IMG_5314.JPG

    IMG_5314.JPG

    • beerdrinker
    • Media item
    • Comments: 0
    • Album: New Dyna-Glo vertical offset smoker
  8. IMG_5313.JPG

    IMG_5313.JPG

    • beerdrinker
    • Media item
    • Comments: 0
    • Album: New Dyna-Glo vertical offset smoker
See more
Top Bottom
Back
Clicky