What do you use to clean your probes?

Discussion in 'General Discussion' started by reasoning, Nov 17, 2013.

  1. reasoning

    reasoning Smoke Blower

    Scrubbed my probes with dawn and a scrub sponge and wasnt touching the gunk so this got me wondering what others use
     
  2. dward51

    dward51 Master of the Pit OTBS Member

    You talking about the probe end ("the probe") or the stainless braided wire sheath?   Dawn & kitchen scrubber sponge works fine for me on the "probe", but the braid is another story.  I think it never gets nice and shiny again.
     
  3. reasoning

    reasoning Smoke Blower

    Just the probes, very think residue on them..... Maybe sos pads would work?
     
  4. pineywoods

    pineywoods Smoking Guru Staff Member Administrator Group Lead SMF Premier Member

    I use Alcohol prep pads most pharmacy's have them this also disinfects them
     
  5. mdboatbum

    mdboatbum Master of the Pit OTBS Member

    For the thick residue I've used plain dishwashing liquid and a scrub pad. If it still won't come off, a little Easy Off might do the trick. I'd spray it on a sponge and wipe on the probe though, don't want that stuff getting into the joint where the cable joins the probe. And wear gloves.
     
  6. dburne

    dburne Meat Mopper

    I use Dawn dishwashing liquid and a sponge/rag , have done 4 smokes with my probes so far and seems to clean them ok. Not super shiny but at least clean.

     The flexible wire close to the probes is another story, but I don't worry about that too much as I don't want to damage especially where it connects. I get it as clean as I can without putting much stress on them.
     
  7. mike johnson

    mike johnson Master of the Pit Group Lead OTBS Member

    I use dish soap with a sponge and then use prep pad same as pineywoods.
     
  8. millerk0486

    millerk0486 Meat Mopper

    I use a dish soap and a paper towel and my finger nail if needed. I will run the cable through a damp paper towel with a little soap, but never drench it. The residue shouldn't really throw the reads off, so I don't stress over getting every spec of the stuff off of it. As long as the meat, sauce, etc is off, I'm good.
     
  9. I spray my probes with pam before each use really helps with cleanup.
     
    Last edited: Nov 20, 2013
  10. venture

    venture Smoking Guru OTBS Member

    I try?  Unless I have had too many brews?

    I try to clean them as soon as I pull them out of the meat.

    A little Dawn and a gentle scrub.

    Soak the wires and probes in lots of water?  That will get you buying lots of new probe wires?  Even leaving the pit probe outside in humid and foggy winters like we have here will get you spending money on pit probes?

    Good luck and good smoking.
     
  11. rabbithutch

    rabbithutch Master of the Pit OTBS Member SMF Premier Member

    Try Simple Green. Soak them if the gunk is really bad
     
  12. dburne

    dburne Meat Mopper

    Hey thanks for that tip, will give that a try on my next smoke.
     
  13. cholla

    cholla Newbie

    I get a damp paper towel and dip it in ashes, then scrub with that. It cuts the smoke residue easily.
     

Share This Page