weber smokey mountain and maverick et 732

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

ribking

Newbie
Original poster
Jun 9, 2014
22
10
Western New York
I was wondering if anyone has found a good mod for running the thermometer probe somewhere other than the door or top vent?  It's a pain running it through the vent because then when you take the top off the probe gets pulled off the grate.  I saw you could buy a kit to switch out one of the screws but the et 732 probe is too big.  Any suggestions would be greatly appreciated! 
 
Thanks guys! It makes me a little nervous because I think it will void the warranty on the smoker but it seems like a great mod.  I actually do have angle grinder too.

@Noboundaries  The new WSM have a grommet already built in for the probe?
 
Thanks these both seem like good options. When I bought the WSM I didn't plan on making any mods ($400 you wouldn't think you'd have to) but after using it for a season it seems necessary. 
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Latest posts

Hot Threads

Clicky