weber lid stack

Discussion in 'UDS Builds' started by nklcolt1911, Jul 15, 2015.

  1. nklcolt1911

    nklcolt1911 Fire Starter

    MN
    has anyone made a exhaust stack for their weber lid? im looking for ideas.
     
  2. jirodriguez

    jirodriguez Master of the Pit OTBS Member SMF Premier Member

    Tough part is going to be cutting the hole without chipping the porcelain coating - if you get a fine enough hole saw that might work. After that if you flare the inside you should be able to drill a few holes and used pop rivets or screws to hold it in place.
     
  3. nklcolt1911

    nklcolt1911 Fire Starter

    MN
    i was thinking of welding it on
     

Share This Page