VAC Master VP112 problems

Discussion in 'Slicers, Grinders, Tools, Equipment' started by reelduel, Oct 8, 2017.

  1. I have had my VP112 for several years now and the same problem keeps showing it's ugly face. Why do the bag fill with air when I and trying to seal them. Here is what I am doing. I put the meat in the bag making sure for a clean seal area on the bag. Put the bag in the machine and lock it down with the bag clip and hit the start button. As I look into the chamber I can see the bag filling up with Air as the machine vacuums down. This makes the bag swell and causes the seal area to buckle and not be flat anymore. This often causes the seal to fail making me to have to retry. I have the vac set to 40 and the seal set to 7 I have played with these and still it happens. What am I doing wrong.
     
  2. rexster314

    rexster314 Meat Mopper

    That's happened to me a couple of times and it was the bag material. VP320
     
    reelduel likes this.
  3. cuebiz

    cuebiz Fire Starter SMF Premier Member

    I have two of the same machines you have, and that only happens to me when the contents are slightly warm.
     
  4. I am using only VM bags. But let me check tomorrow with different sizes and see what it does.
     
  5. I was trying to pack frozen meat today and it did it. While the Chamber is pulling down, at the same time the bag inside is ballooning up.
     
    Last edited: Oct 8, 2017
  6. soobaerodude

    soobaerodude Newbie


  7. I do allow for some of the bag to go past the bar but is blows the bag up so much it causes the bag to buckle and become uneven and hard to make a good seal. If this is normal it is a piss poor design if you ask me.
     
  8. rexster314

    rexster314 Meat Mopper

    Possibly the sealing gasket is kaput?
     
  9. It has hardly even been used. Today it worked fine. But I also used bags almost 2x the needed size too.
     

Share This Page