Tough sausage casings

Discussion in 'Sausage' started by jenny66, Aug 3, 2011.

  1. jenny66

    jenny66 Newbie

    Hi all,

    I have only tried smoking some polish sausage a few times and here is the problem I 've had.

    The casings turn out really tough!

    I smoked them at about 150 or so for at least 4-5 hours as per the instructions I had.

    I soaked the natural casings in water with a little vinegar for about an hour prior to stuffing..

    Did I do something wrong.

    Any help is appreciated because I'd like to try again soon.

    JEN
     
  2. alblancher

    alblancher Master of the Pit Group Lead OTBS Member

    I normally only use salt water when I soak casings, not sure if that has anything to do with it or not  I also bring sausage up to 165  internal temps and I don't think you can do that at 150 degrees chamber temps.  If the sausage is cured why not smoke at the lower temp for a couple of hours and then turn up the heat and bring internal temp to at least 160 maybe 165.  This will help with the casings.

    If the sausage is fresh with no cure then you only have 4 hours to get to your internal temp.  I am saying 165 is safe, others will say 160.  Either way I don't think you are getting the casings and meat hot enough.
     
  3. fpnmf

    fpnmf Smoking Guru OTBS Member

    Fl
  4. jenny66

    jenny66 Newbie

    Thanks Al, 

    I will try that!
     
  5. boykjo

    boykjo SAUSAGE MAKER Staff Member Moderator Group Lead OTBS Member

    You didnt do anything wrong........You rinse the inside and soak the casings If they were packed in salt I would soak overnight before stuffing. What you did should have came out fine.  I would try another brand. I prefer natural casings in a salt brine solution for best results.

    Joe
     
  6. did you soak them in vinegar?
     
  7. nepas

    nepas Smoking Guru Staff Member Moderator Group Lead OTBS Member

    Soak the casings in cold water 2-3 hours prior to stuffing. The vinegar just makes the veins take on a transparent look (better eye appeal)

    150 is kinda high to start with. Try 130 for 1 to 1.5 hours to dry the casing. This will help the casing dry and make a better bond with the meat surface. It also helps with smoke bonding to the casing surface. Then you can bump the heat to 140, 150, 160, 170....Try not to exceed 175.

    Remember to add your cure 1.
     

Share This Page