to water pan or to not H20 pan in UDS

Discussion in 'UDS Builds' started by bowtieracin, Jul 2, 2011.

  1. bowtieracin

    bowtieracin Smoke Blower

    i just built my first UdS and am going to try it out today. My question is do i need to use a waterpan or not which is better? thanks so much in advance!
     
  2. meateater

    meateater Smoking Guru SMF Premier Member

    I say try it both ways to see what you like . Personally I don't like sour smoke so I use a water pan to catch all the fat. No sour smoke and a clean drum when finished. This is just my personal preference. [​IMG]
     
  3. bowtieracin

    bowtieracin Smoke Blower

    i just didn't know if it will work better or worse with or without it? As far as holding temp or running to hot.
     
  4. helljack6

    helljack6 Meat Mopper SMF Premier Member


    It will hold temps about the same with or with out, what you WILL see out of it is not nearly drastic temp spikes and a longer heat up time since you're having to heat the mass body of water as well. UDS weren't designed to have water pans in them because they're already inherently a moist atmosphere. If you look at the BDS that Rocky rmarkets, there's no water pan included because as the heat rises the drippings fall into the fire and steam back up into the meat and surrounding area, hence your moisture. I've got 12 UDS, each one made differently in one way shape or form, and I had the same question you had during my 4th and 5th drum, so I built it to take a water pan, found out it really didn't make that much of a difference except for heating it up, that took longer.
     
  5. meateater

    meateater Smoking Guru SMF Premier Member


    That's what I like about having a water pan, it keeps my temps even, mine runs at 250° consistent. [​IMG]
     
  6. cromag

    cromag Smoking Fanatic

    The center of my rack was 15-20 degrees cooler cause of the water pan blocking the center so I eliminated the pan on the last two smokes and the butts turned out just fine. I also quit foiling at 160 and just let it ride to 200*
     
  7. bowtieracin

    bowtieracin Smoke Blower

    Well i used it for the first time yesterday without a pan and it worked very good!! i think i should have put a little more lit charcoal in it to get it goin i only put a small half of  a chimmney but it held great and the chicken turned out awesome!!! think i will forget the pan dont need it.
     
  8. fwismoker

    fwismoker Master of the Pit

    What i'm going to try (when it's up and running) is to place 2 small water pans on the outside area of the grate that can hold a deflector plate and let the drippings go right down in the fire...see if that will give the best of both worlds. (holding good temps and flavor of the drippings)
     

Share This Page