TA4 snr used as on/off

Discussion in 'Smoker Builds' started by kimsbrew, Aug 10, 2015.

  1. kimsbrew

    kimsbrew Newbie

    Wired a TA4 for on/off. PID functions are all Off. oUd is set to cool. Therefore, if PV is higher than SV, out1 light is on. Using a SS relay input of 2.5 to 30. Output 120 vac. However, the input reading on the relay using a meter is 1. No reading on the output side of the relay. 

    Any ideas would be helpful.

    Thank you.

    Using a light as a load when cooling is called for. Out1 is lit also.
     
    Last edited: Aug 11, 2015
  2. okiedave

    okiedave Smoke Blower

    ...my first major in college was electrical engineering and I still didn't follow that.
     
  3. jckdanls 07

    jckdanls 07 Master of the Pit Group Lead OTBS Member

    :yeahthat:
     

Share This Page