Suggestions for Sealing up Bolt Holes

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

iowa josh83

Smoke Blower
Original poster
Mar 22, 2011
128
14
Iowa
Title says it all. My fridge interior has several holes from the bolts that held shelves and what not. What should I use to seal up these holes? Some might get used for shelf brackets but the others I will need to seal up.

Thanks!

-Josh
 
Would a short sheet metal screw with washer do the trick? If the screw is too small in diameter, insert a piece of wire in the hole for the screw to grab.
 
If you don't have any bolts or screws to plug the holes with you could super glue some thin metal flashing over them (or epoxy). If you apply the patch on the outside of the smoker it won't get hot enough to compromise the glue.
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Latest posts

Hot Threads

Clicky