smoke intake to exhaust question

Discussion in 'Reverse Flow' started by detree, Feb 4, 2015.

  1. detree

    detree Newbie

    been researching a lot on vertical reverse smokers......my question is what should the ratio of smoke into the CC be compared to smoke out. Example......do I make both side walls and the back "false" with a one inch gap and use dual exhaust on the sides in the middle?......why not half of each side in the middle and the exhaust in the rear? Hope this make sense lol.....
     
  2. daveomak

    daveomak Smoking Guru OTBS Member SMF Premier Member





     
  3. detree

    detree Newbie

    ok...so I am figuring twice the intake to exhaust?.......
     
  4. detree

    detree Newbie

    its was easy with a drag racer.......just paint the header and where the paint did not burn.....cut it off lol

    gotta run what ya brung

    just lookin to bring something good to the table
     
  5. daveomak

    daveomak Smoking Guru OTBS Member SMF Premier Member

    Those drawings aren't to scale...    equal CC inlets and CC exhaust....   this design hasn't been calculated....  only estimates of "theoretical" assumptions for a doable vertical smoker... minimizing friction loss.....
     
  6. daveomak

    daveomak Smoking Guru OTBS Member SMF Premier Member

    You must have been on the strip when I was....  Late '60's..... 
     
  7. lendecatural

    lendecatural Smoking Fanatic

    Aaah for the days when a distributor wrench and screwdriver were all that were required for a good tune and the words Laptop or code reader had not yet been invented.
     
  8. I remember those days

    Gary
     

Share This Page