Smoke Box Door (Wood loader)

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

sheltbt

Newbie
Original poster
Feb 7, 2016
8
12
 I have a problem with it. On the chip loader it does not strop turning when it dumps the chips. And also you can pull it out without turning it to unlock. The tabs seem to be straight. What can I do to remedy this?

Thx in aadvance
 
Last edited:
Thx, yes I have already bought the AMNPS. I didn't figure it was a problem. Thx again
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Latest posts

Hot Threads

Clicky