Sealing the Gaps

Discussion in 'Slicers, Grinders, Tools, Equipment' started by eodnick, Feb 28, 2015.

  1. eodnick

    eodnick Newbie

    Hey there,

    I recently starting using the Digi q controller with a fan on my Bayou Classic ceramic smoker. Here's a picture if you're not familiar with my less known smoker:

    I now need to seal the gaps at the bottom of my smoker where the metal meets the ceramic. I was thinking of using some type of high temp caulk, but am unsure if that will work. Is there any specific product that I could use? What have yall used in the past for sealing gaps?

    Thanks!

    A few pictures to help explain:


     
  2. inkjunkie

    inkjunkie Master of the Pit

    Better hope you never need there assistance.
     
    Last edited: Feb 28, 2015

Share This Page