Saturday Brisket

Discussion in 'Beef' started by dsbdsb, Nov 27, 2013.

  1. Hello Everyone,

     I plan on smoking brisket this Saturday. I have a packer, just under 10#, an plan on using the rub recipe posted by Waucedah. I have the 30" Masterbuilt electric smoker, not the one with the glass door, and plan on serving the brisket around 5:00-5:30 after resting for about 1.5 hours. So I plan on starting the smoker about 0300 and setting for 225.  I will not be opening the smoker to mop the brisket, i will be filling the water pan with apple juice. I was thinking of setting the internal thermometer at about 180, then pulling the brisket and wrapping with foil until it gets to about 185, then pulling it. At that point i think i'll seperate the flat and point.  

    I also have a rack of st louis style ribs i am throwing in. this will be the only time i plan on opening the smoker….. any thoughts as to how far out i should put in the ribs. Ideally when i pull the brisket to rest, i would like to serve the ribs also (or close to that time). 

    I plan on using a mixture of apple wood and hickory chips. 

    this isn't the first brisket i have done, but by no means am i a pro. So looking for any thoughts or advise.

    thasnks for your time,

    Dan
     
  2. h
     
    Last edited: Nov 28, 2013
  3. demosthenes9

    demosthenes9 Master of the Pit OTBS Member

    I'd be very careful making sure that the brisket doesn't drip onto the ribs, or vice versa.  Not a health concern, but rather, that of cross flavoring, (ribs tasting like brisket or brisket tasting like the ribs.)

    As for the timing on the ribs, are you going to be foiling them at all ?  Or just straight smoking ?
     
  4. I was planning on foiling at 180, the pulling it out at 187 to rest for an 1-2 hours while the burnt ends go back in for about an hour
     
  5. dirtsailor2003

    dirtsailor2003 Smoking Guru OTBS Member

    Ribs will take 5-6 hours, at 225°-250°.
     
  6. Maybe I'll start the ribs in the smoker and finish in the oven, they are more of an appitizer for the kids coming anyway.  
     
  7. do you thing 225 is good for the brisket? It will be about 38-45 degrees when i start in the a.m.  I'll let the smoker run at temp for about 40 minutes before i put in the brisket
     
  8. dean74

    dean74 Smoke Blower

    Sounds like a good plan but I wouldnt pull the brisket til it hits about 200 degrees
     
  9. Use the toothpick test on the brisket
     
  10. Brisket has been in just over 6 hours now and smells delicious. Currently my thermometer is reading 175 degrees. 6.5 hours left to go according to 1.5ish hours per pound. Wondering if it will be done too early?

    Dan
     
  11. dean74

    dean74 Smoke Blower

    I would throw the one and a half hours per pound out he window if it hits 200 and you can put a toothpick or thermometer in and it feels like butter your done. My 15lb briskets are usually done in 10 hours
     
  12. nmaust

    nmaust Meat Mopper

    I had a brisket finish earlier than planned a few weeks ago, so I left it wrapped and packed in the cooler for 4 hours or so. It was perfect when I pulled it out too slice it.

    Sent from my SCH-I535 using Tapatalk
     
  13. dirtsailor2003

    dirtsailor2003 Smoking Guru OTBS Member

    Every piece of meat cooks differently. You may stall out somewhere too. I also don't rely much on times per pound and use the toothpick method.
     
  14. Thanks Dean
     
  15. Looks like it might be holding here, i'll keep checking it though. When you use the toothpick method, where are you probing the brisket? I assume you are going through the flat and not the point due to the fat. 
     
  16. dean74

    dean74 Smoke Blower

    how did it turn out?
     

Share This Page