Request for pic of CharGriller Hinge

Discussion in 'Charcoal Smokers' started by gianni, May 21, 2013.

  1. Hello All!

    I'm new here and need a little help, please.  Can anyone with a CharGriller Super Pro post a pic of the upper body welded tab that mates to the cylindrical hinge on the lower body?  I'm in need of fabricating a similar tab that mates an older Super Pro top to a newer Super Pro (with Clevis pin) bottom.

    A pics of the tab and clevis would be wonderfully helpful and gratefully appreciated!

  2. cliffcarter

    cliffcarter Master of the Pit Group Lead OTBS Member

    Pit needs a good cleaning, but there you go.

  3. Hi Cliff,

    Thank you much for taking the time to make and upload these images.  They are perfect!  I have located a 1/2" steel sleeve that fits into the lower body pivot hole perfectly.  Now I just need to determine the correct dimensions for the upper body hinge 'tab'.  My initial tests didn't work too well since the upper body would not open all the way.  I figure a few more tests and I'll be there.  Your pics will certainly help!

    Thanks again,


Share This Page