Question about controlling temp when smoking jerky

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

rob sicc

Smoking Fanatic
Original poster
May 5, 2008
725
26
new jersey
Hi all,

I hope everyone is well out there.  I haven't been on for a while but I broke my smoker out yesterday and started smoking some jerky.

I had some problems and ran right here.

When I was smoking, the temp went up over 200 degrees which I find toasts the jerky rather than dries it.  I tried closing the dampers more and more, just shy of risking putting out the fire but it still got to hot.

I have a vertical smoke with an offset fire box.  You can see it in my profile picture. I set up the fire box like I would for a long slow smoke.  I did this because I planned on smoking jerky for a while.  I got frustrated and only did one full load in the smoker.  I didn't want to risk wasting this valuable product.  lol

So can anyone offer some suggestions on how to keep the temp down some?  I was going to open the door but I was afraid it would go down to low then.  I probably should have tried that.

All suggestions are welcome.

Ciao,

Rob
 
Last edited:
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Hot Threads

Clicky