question about beef rib roasts and tenderloins...

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

fatback

Fire Starter
Original poster
May 16, 2008
63
10
Atlanta, Georgia
I know when I oven-roast prime rib and tenderloin, I pull it from the oven around 120 degrees knowing that "temp creep" will take it to a final temp around 130 while it rests -- just the way I like it. Of course, in the oven I am roasting around 300-350 degrees most of the time. Since I have not smoked many large, premium beef cuts in my smoker, and the cooking temperature will be much lower when I do -- around 225-250 -- how much "temp creep" should I expect? Obviously, I want the meat to be "done", but I can't stand carving an expensive piece of beef (usually in front of hungry guests) only to find I have cooked it past medium rare.
 
on rib roasts i take them up to 130-135 deg, foil, wrap in towels and put in a cooler for 1/2 hour or til dinner time. end up with a nice med rare every time.... never did a tenderloin, too much money for a not that great tasting cut of beef, very tender but just lacks taste. take a rib roast any day.
 
Will your smoker just not hit those temps and hold them?

From one Fatback to another, I would say just up your temps.

But to answer the question, yep, the carry over at lower temp cooking will be smaller than at higher temp. Just how much will depend....when you have it resting will it just be sitting on the counter wrapped in foil or sitting in a cambro staying warm? All kind of factor in, but based on what you posted, I would say plan 3 to 5 degrees at 225 to 250 in my experience.
 
When I do tenderloins I try to keep the smoker in the 190-200 range for about 45 mins which typically gets me an internal temp of 115 or so then I transfer the meat to a very hot grill to brown up and bring the meat up to final temp. I use this method when planning to serve the tender either hot as an entree or cold as an appetizer.
 
I can definitely stoke the fire up to get higher temps in my smoker, but I thought the whole point was "low and slow". You recommend more heat and shorter duration for these cuts?
 
My experience is 5 degrees or so as well.I like to hold off on tenting the meat a few minutes to let some of the residual heat on outside dissipate and then lightly tent the meat in a cool oven.....

Whoops sorry about posting so quick after your last question!!!
 
Without a doubt......the whole low and slow thing is really for tougher meats that have a lot of connective tissue that takes time to break down, the cuts you mention don't need that time.

If your smoker can hold the temp, then do it. Nothing to gain from "low and slow" on those cuts IMO.
 
I have smoked a many of ribeyes and I always smoke them at 220-230 and take them too about 130 for rare and let them rest with some foil just layed over the steak and then it's enjoy. As always.
 
Ditto on that Mark.
 
Quote:
Originally Posted by mballi3011
I have smoked a many of ribeyes and I always smoke them at 220-230 and take them too about 130 for rare and let them rest with some foil just layed over the steak and then it's enjoy. As always.




Ditto on that Ron....
PDT_Armataz_01_34.gif
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Hot Threads

Clicky