Powder Coating

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

fishwrestler

Smoking Fanatic
Original poster
OTBS Member
Apr 4, 2010
646
34
Loomis,CA
My Dad and I have a pull behind rig. Is made out of metal for the frame and stainless panels inside the framed sections. I would like to get all the metal pats powder coated. The shop and all that I have read said the powder coating will hold up to the heat. Which usually doesn't get over 450 deg internally. Any one here have experience with powder coating their Smokers/BBQ and if so how is it holding up
Thanks Again
Robert
 
not on smokers, but have seen motorcycle tailpipes that are powdercoated, and they hold up. Powder coating is usually cured with heat around 360*F.
 
Well I just found out I won't have a job after July one so wife said find a job and you can get it done. So on hold until I find a new Job :(
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Latest posts

Hot Threads

Clicky