Ok I have looked around a little and read opinions on plywood and particle board but I have a boat load of scrap lumber and just one question.
Most of the lumber is pine as in 2x4s, 2x6s, 2x8, 2x10s and 2x12's. I was thinking of doing the tongue and groove thing and building a smokehouse in my barn.
The bottom 4ft will be cement block. Is pine ok for the walls?
Your advice/opinions greatly appreciated.
thanks
Dan
Most of the lumber is pine as in 2x4s, 2x6s, 2x8, 2x10s and 2x12's. I was thinking of doing the tongue and groove thing and building a smokehouse in my barn.
The bottom 4ft will be cement block. Is pine ok for the walls?
Your advice/opinions greatly appreciated.
thanks
Dan