Not a good start with MES 40"

Discussion in 'Electric Smokers' started by smokypgh, Aug 17, 2014.

  1. smokypgh

    smokypgh Newbie

    After much research here I ended up going with 1st all stainless version of the MES 40. While putting the thing the pin holding the latch in place sheared at either end. I have contact masterbuilt but was really hoping to season the thing today. Does anyone know of an off the shelf solution I could pick up from home depot that would require modifications to work? 


    I have used the search function but unfortunately not found a previously discussed solution. 
     
  2. foamheart

    foamheart Smoking Guru OTBS Member SMF Premier Member

    Just lean a chair or a shovel up against the door. Long as the vent is cracked there should be little trying to open it. Temporary fix till the part comes in.
     
  3. bearcarver

    bearcarver Smoking Guru OTBS Member

    Or another temporary cure-----Bungee cords.

    Bear
     

Share This Page