Need some suggestions

Discussion in 'Smoke Houses' started by scotbradly726, Sep 24, 2016.

  1. scotbradly726

    scotbradly726 Newbie

    Hey y'all! Finally after 10 years I decided it was time to upgrade and build a bigger smokehouse. I went from 2X2 and 9' tall fired with a 15,000BTU PROPANE BURNER TO A 3X3 and 7' tall fires with a 30,000BTU double propane burner. I'm including some picks of the new smoker.

    I'm having some temp issues. Particularly cold spots. I get good heat in the back and on the right side, but the left side is cold and so is the front. Looking for some tips on how to get more even heating....[​IMG]
     
    Last edited: Sep 24, 2016
  2. wayne gray

    wayne gray Newbie

    Nice smoke house. You might want to try putting a piece of steel above your heat source. Make it 6" smaller than your smoker heat should radiate up more evenly.Cant hurt to try!
     
  3. daveomak

    daveomak Smoking Guru OTBS Member SMF Premier Member

    Where are the inlets and exhausts located ??   Got pics...
     
  4. scotbradly726

    scotbradly726 Newbie

    I was thinking maybe suspending a steel fan above the fire too. Maybe that would cause the air to move more evenly?


    Sent from my iPhone using Tapatalk
     

Share This Page