Need some help with purchasing an Auber

Discussion in 'Slicers, Grinders, Tools, Equipment' started by moon5hine, Feb 16, 2012.

  1. moon5hine

    moon5hine Newbie

    I am looking to purchase an Auber temp controller, however I am unsure which blower to get.  I have a 18.5" WSM and am sure the standard 6.5 blower would suffice.  However I was interested in hearing if the upgrade to the 20 would be beneficial or if it would be too much.  I do not do many high heat cooks.  Thanks in advance.
     
  2. timleo

    timleo Smoke Blower

    I use the standard blower and it works just fine. The temperature doesn't fluctulate too much even though the blower does run more than 45% of the time.   I'd be thinking the 20 cfm blower might run for short bursts and the temp would fluctulate more.

    I'm interested to see what other people use
     
  3. mmain1

    mmain1 Newbie

    You might also email Auber and see what they say.  Couldn't hurt.

    I haven't used one but I was under the impression the 20cfm was for large stick burners.  Too bad they don't offer a 10cfm or something in between the 6 and the 20.
     
  4. moon5hine

    moon5hine Newbie

    Thanks for the info.  I took your advice and sent them an email.  I asked about a 10 as well.
     

Share This Page