need help modding my ecb

Discussion in 'ECB Owners Group' started by stephen1855, Nov 13, 2013.

  1. just got it about a month ago and not really sure where to start on modding it out. 
     
  2. tread

    tread Fire Starter

    This is a must read (link removed).  and this one (link removed)
     
    Last edited: Nov 14, 2013
  3. Thanks, I think I found what ill be doing this weekend.
     
  4. bobank03

    bobank03 Smoking Fanatic

    Stephen 1855;

    Most of us have done a lot of mods to our ECB's. Start with reversing the legs and resting the pan on bricks and then getting the gasket to seal the lid.

    There are some really good posts already on the ECBOW. What are you thinking about doing first? 
     
  5. start with messing with the pan to get some extra airflow and not smoother my coals and getting a new temp gauge. the reversing the legs and getting bricks will probably be done as well.
     
  6. flash

    flash Smoking Guru OTBS Member



    Don't forget extra holes in the fire pan. Playbox sand instead of water for higher temps. My firepan rested between three concrete blocks. Easy to lift the smoker right off the pan to add more coals when need and you didn't lose the heat. Depending on how I vented the blocks, I could easily add air flow. A full pan of coals could deliver 450º, so I was able to cut down on the amount of charcoal I used by quite a bit.
     
  7. magslam

    magslam Smoke Blower

    Just google "ecb mods". There's plenty to read.
     

Share This Page