Mypin ta4

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

syncman

Newbie
Original poster
Jan 27, 2016
3
10
I will admit that I am a beer brewer, and this seems like the best place for help.  My temp controller is setup for testing with a SSR controlling a lamp, but the output led on the PID flashes continuously. This flashes the lamp via the SSR. The temp probe works fine too, so wiring seems OK. I may have messed up a setting trying to change from C-F.

If I wanted to maintain a temp. of 156F, and never allow more than 3F above or below that, what would the settings be for alm1 and alm2?
 
Last edited:
I would post your question in the beer & ale forum.

Just go to Forum Nav: find beer & ale then post in there.

Good luck.

Al
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Hot Threads

Clicky