Mouse in my Masterbuilt

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

pitpastor

Newbie
Original poster
Jul 7, 2013
17
10
Rio Rancho, New Mexico
This past week I discovered that a mouse has been sneaking into my Masterbuilt Pro Dual Fuel smoker. I set a couple of traps under it, and then moved them inside hoping to catch him but no luck thus far. Today I went to check the traps and prep the smoker for a pork tenderloin and there he was staring at me as I opened the door. He crawled out and ran off before I could do anything.

I'm going to try some different traps and maybe even some glue boards to try and catch this sucker. Anyone else have issues with mice in their propane smoker? Any tips on how to keep them out other than keeping the smoker nice and clean? Any tips on best way to get rid of this one? I think he must be living inside a yucca plant or under a retaining wall nearby. Thanks in advance for any thoughts.
 
i have the masterbuilt electric. w/ door closed no way for mouse to get in. Any way to seal up the smoker?
 
Came here to search and glad I'm not the only one! Opened up the smoker this morning to put some butts on and immediately saw nest on bottom, then the little f&*$r ran right out and under my deck. Threw an old piece of bait/poison out under to follow him...maybe he'll get it, who knows.

I've cranked the smoker up to 375 and will let it run for about 20 minutes before going at the grates with a wire brush to clean...that should do the trick, don't you think?
 
Came here to search and glad I'm not the only one! Opened up the smoker this morning to put some butts on and immediately saw nest on bottom, then the little f&*$r ran right out and under my deck. Threw an old piece of bait/poison out under to follow him...maybe he'll get it, who knows.

I've cranked the smoker up to 375 and will let it run for about 20 minutes before going at the grates with a wire brush to clean...that should do the trick, don't you think?

A good burn out should do the trick. Then spray down with vinegar and do another burn out.
 
  • Like
Reactions: dslunceford
Came here to search and glad I'm not the only one! Opened up the smoker this morning to put some butts on and immediately saw nest on bottom, then the little f&*$r ran right out and under my deck. Threw an old piece of bait/poison out under to follow him...maybe he'll get it, who knows.

I've cranked the smoker up to 375 and will let it run for about 20 minutes before going at the grates with a wire brush to clean...that should do the trick, don't you think?
heres' an article I found but have not needed to do.
Richie
http://smokingmeatforums.com/index....-i-know-but-bear-with-me.256817/#post_1650279
 
We use dryer sheets at the hunting cabin . In the cabinets , on the beds even in the shed . No signs of mice any more . Might be a cheap try til you get it figured out .
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Latest posts

Clicky