MES temp probe

Discussion in 'Meat Thermometers' started by africanmeat, May 17, 2011.

  1. africanmeat

    africanmeat Master of the Pit OTBS Member

    OK it is my turn for a stupid  question .

    did any off you MES owners drill a hole in the door off the MES and fix in a temp' prob (like in a reverse flow )so you can glance at the temperature as you pass by.if yes did it work?

    [​IMG]
     
  2. beer-b-q

    beer-b-q Smoking Guru OTBS Member

    Nope, all I do is feed the Probe down through the top vent since I keep it all the way open it works great.  I usually have several probes going at once...
     
  3. smokinal

    smokinal Smoking Guru Staff Member Moderator OTBS Member SMF Premier Member

    You can just shut the door on the wire too, it won't hurt the probe wire or the door insulation.
     
  4. africanmeat

    africanmeat Master of the Pit OTBS Member

    sorry i did not  explained   myself correctly
    i mean a permanent one like this

    [​IMG][​IMG]
     
     
  5. smokinal

    smokinal Smoking Guru Staff Member Moderator OTBS Member SMF Premier Member

    If it were me I would not drill a hole in the door. I would get a digital therm and run the wire through the top vent or in the door, then shut the door on the wire.
     

Share This Page