MES 40 Building up pressure

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

samaridad

Fire Starter
Original poster
Nov 14, 2009
47
10
Mableton, ga
Has anyone else had your unit build up pressure from wood chips then blow pressure out the wood chip loader. The top vent is wide open. and smoke blows out there also.

model number 20070211 from Sam's. The retro smoke box is not installed yet.

I took a video of this not sure how to post to this site.

Thanks for your help ahead of time.
 
While it is in operation, did you open the door? pull out the chip tray?

When the chips start to smoke, and volitile particles are emitted from the chips, if enough oxygen is added to the mix there will be a small explosion. If none of the above is happening, check the door seal.

We need more info...

Dave
 
While it is in operation, did you open the door? pull out the chip tray?

When the chips start to smoke, and volitile particles are emitted from the chips, if enough oxygen is added to the mix there will be a small explosion. If none of the above is happening, check the door seal.

We need more info...

Dave
This is exactly what is happening . mine used to do it every now and then. usually when i opened the chip chute to add more chips.
 
 
the chip loader is in place (full insertion) the door is closed and I saw the explosion of smoke on the back deck. It was raining so dont know if that changed anything. Unit under the barbecue awning. the door seal is fine. Checked with a dollar bill.
 
My 1st MES 40 did it too, with chips in the pan.

I think it's called a "Backdraft"

Todd
 
i sent this clip to MB last week they got back to me wanting the model and serial # Im sure they will figure it out. They have the best customer service.....
 
 
My 30 did this until i tweaked the chip pan to get it off the heating element...it is the chips catching on fire. It is a easy fix i bent the slides on my chip box to keep the chip tray about a quarter inch off the element. I really fixed the problem by getting a A-MAZE-N from Todd then following it up with the pellet burning  model also.
icon14.gif
 
I am sure thankfull for this forum. I almost bought a MES but after reading about all the Mods and problems and the solution is to turn it off and use todds AMAZn Smoker. Now i just need to save up to get todds units.

Karl
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Latest posts

Hot Threads

Clicky