Hello all,
This is my first post to the forum, so please bare with me. I recently acquired an MES 30 from my father in law. He said that all it needed was some new wiring and some connectors.
I went ahead and drilled out all of the rivets holding on the rear cover and replaced some of the wire and the connectors going to the heating element. I put everything back together and fired her up. She came on and started to get warm. I started cleaning up the ridiculous mess that I had made. I turned around to check on it again, and it had shut off. No popped breakers. I pulled the rear cover and double checked everything. I got nothing. I unplugged it and plugged it back in, still nothing. I am by no means a master electrician, but I can usually stumble my way through most projects. Anybody have any helpful advice on the matter?
Thanks,
Brandon
This is my first post to the forum, so please bare with me. I recently acquired an MES 30 from my father in law. He said that all it needed was some new wiring and some connectors.
I went ahead and drilled out all of the rivets holding on the rear cover and replaced some of the wire and the connectors going to the heating element. I put everything back together and fired her up. She came on and started to get warm. I started cleaning up the ridiculous mess that I had made. I turned around to check on it again, and it had shut off. No popped breakers. I pulled the rear cover and double checked everything. I got nothing. I unplugged it and plugged it back in, still nothing. I am by no means a master electrician, but I can usually stumble my way through most projects. Anybody have any helpful advice on the matter?
Thanks,
Brandon