Maverick ET-732

Discussion in 'Meat Thermometers' started by pacedawg, Nov 23, 2013.

  1. pacedawg

    pacedawg Fire Starter

    Does it make sense that the Maverick temperature is displaying heat 25 or so degrees LESS than the thermometer that came with the Brinkmann offset? 
     
  2. It can. Do a boil test and see what the Maverick reads. That is the best way to see.
     
  3. pacedawg

    pacedawg Fire Starter

    I did and it was close. I'm just surprised. I would have thought that the temps would have read visa versa. I know heat rises but I was assuming that the Maverick would have been higher than the standard thermometer. 
     
  4. timberjet

    timberjet Master of the Pit

    look on the back of the thermometer and see if there is a nut there. I have one that is adjustable and I think quite a few are. Not that you will get a super accurate reading with that one anyway but you might get it closer.
     
  5. just temember the boil point may not be 212*F depending on altitude and pressure.
     
    gimmeharmony likes this.
  6. davidhef88

    davidhef88 Master of the Pit OTBS Member

    factory therms are almost always inaccurate.  Not surprised it is off that much, my factory therm works fairly accurate to about 250* then goes way off in either direction.
     
  7. venture

    venture Smoking Guru OTBS Member

    Factory therms are a trip!

    On my offset, the factory lid therm reads about 75 degrees LOW.

    But that is at normal smoking temps?

    Above and below normal smoking temps?  The differential will vary. (technical language right there)   [​IMG]

    Smokers could be cheaper if they just left out the worthless therms they put in them!

    Good luck and good smoking.
     
    Last edited: Nov 23, 2013

Share This Page