I am getting ready to mod my MES30 for Todd's AMNPS. HERE's the plan:
Remove grease box from bottom.
Replace with flat mailbox with 2" spacers.
Cut 3" hole in mailbox to match up with same in bottom of smoker.
Mailbox is 10 1/2" by 8" by 3 7/8".
Campbells soup can is 3".
Fit can between the two openings.
Fit rectangular open-ended tent over can opening in smoker under heat element.
I figure mailbox lid will be adjustable damper.
Top vent:
Cut hole in top or back of smoker and install vent hood with damper, figure I can control flow from bottom and top.
Remove water and chip bowls and rack, replace with a new drip pan.
I'll try to post pics of planned materials.
Thanks ahead for ideas!
AZBullfrog
Remove grease box from bottom.
Replace with flat mailbox with 2" spacers.
Cut 3" hole in mailbox to match up with same in bottom of smoker.
Mailbox is 10 1/2" by 8" by 3 7/8".
Campbells soup can is 3".
Fit can between the two openings.
Fit rectangular open-ended tent over can opening in smoker under heat element.
I figure mailbox lid will be adjustable damper.
Top vent:
Cut hole in top or back of smoker and install vent hood with damper, figure I can control flow from bottom and top.
Remove water and chip bowls and rack, replace with a new drip pan.
I'll try to post pics of planned materials.
Thanks ahead for ideas!
AZBullfrog